Now click in the top ruler and drag downwards to pull out a guide. Also make sure that the layer you want to snap to is active. Start by placing one image on your page and make sure the rulers are visible (View – Rulers). Once you have snapping turned on (and set for Layers) you can use it to pull out guides to fit an existing object (assuming the object is on its own layer). Pull out guides and snap to existing objects For example, if you have a guide very close to a layer edge, Photoshop might have a hard time knowing which of the two you want to snap to. It’s usually best to leave these all turned on but there may be time when you want to uncheck one of more of them. Underneath Snap you can select exactly what you want things to snap to – guides, layers etc. Check that Snap is ticked in the View Menu. Turning on snapping means that your objects will snap to your guides (that is, when you get close your object will jump to align with the guide and you don’t have to do it by eye). You can use whatever units you want here – pixels, centimetres, inches – just type is after the figure, eg: 450 px, 4 cm or 3 in (note: you can type inches or in but not “) 2. You can choose to set a horizontal or vertical guide and enter the exact position you want it to be. When you know exactly where you want to place a guide, use the New Guide option under the View Menu. It looks messy and unprofessional and gives an impression of sloppiness that you definitely don’t want associated with your work! Setting up a simple series of guides will allow you to accurately place your images so this doesn’t happen. How often have you seen presentations like this where the images are not properly aligned?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |